 PERFECT!!!, 4.16.2011
|
|
Reviewer: Robert Kimbrell (inman, SC)
|
Wow, for the price you can't beat it! Service was great, shipping was extremely fast. Great quality! Highly recommended!
|
|
|
Excellent choice, 9.14.2010
|
|
Reviewer: Riley Allen (Vernal, UT)
|
First called Jeff to double check if it would work and it did. Takes some extra time to fit my Termi's on and line everything up so it would seal up and not leak. Louder, lighter and the sound on decel can't be beat. Didn't even have to re-program my ecu or change anything. Did clean the whole header with rubbing alcohol before I fired it up so it would get a nice color. Still can't believe it was as cheap as it was and I wish I did it sooner.
|
|
 Very Good Value - Recommended, 7.26.2009
|
|
Reviewer: Kerry Suche (Winnipeg, Manitoba)
|
Easy install, no real issues with fit. A bit fussy fitting to S pipes but no problems. Pipe is very well finished, looks great and follows the contour of the engine closely - does not hang too low! Great sound, especially with Termi's (or any aftermarket pipes I'm sure). Good bang for the buck and my choice even if I was to do it over again!
|
|
|
Head of the class header, 10.7.2007
|
|
Reviewer: Jeffrey McClanahan (Los Gatos, CA)
|
Very nice finish on pipe. Installation was very simple and everything fit perfectly without any "creativity." Was waiting for my mufflers to be cored and rode with this piece alone - my ears are still ringing! Would definitely recommend this product for the exceptional fit, finish and reasonable price.
|
|
|
Outstanding piece!, 9.29.2007
|
|
Reviewer: Dan Butts (E. Dummerston, VT)
|
I've installed so many custom stainless exhausts on cars and bikes that I couldn't even count them. This is the first time that I have ever installed a header that simply fit perfectly. It looks fantastic, follows the countours of the engine perfectly, leaves plenty of room for unobstructed oil filter access, and totally cleans up the look of the bike by eliminating the "udder" from the bottom of the motorcycle.
I looked at many options before I purchased this system, and chose this one for budget considerations. In hindsight, I would buy it again regardless of price. Marving rules.
Installation tips:
1. Route the oxygen sensor harness on the right, not left, of the bike.
2. Clean the system with a rag saturated with brake cleaner after installation and BEFORE STARTING THE BIKE. This will eliminate finger prints being permanently outlined in the exhaust after heating up.
3. Any stainless exhaust system will look much better in the long-term if you oil (WD-40) it prior to it's first heat cycle and after the next few subsequent heat cycles. Use some 00 steel wool and take the time to work it in well. This will lead to a shiny, rich golden hue instead of a dingy brown.
I would highly recommend this system.
|
|
.focus();)
